RAMPA KNOCK-IN INSERTS TYPE TSZ
Product information "RAMPA KNOCK-IN INSERTS TYPE TSZ"
RAMPA knock-in inserts type TSZ with continous internal thread and four strong pikes on the shank for strong hold without torsion.
Product attachments "RAMPA KNOCK-IN INSERTS TYPE TSZ"
Login
Accessories
RAMPA MUSHROOMHEAD SCREWS TYPE KT
RAMPA mushroom head screws type KT with hex drive and decorative head for visible joints.
RAMPA FLAT HEAD SCREWS TYPE KF
RAMPA flat head screws type KF with hex drive and decorative head for visible joints.
RAMPA COUNTERSUNK SCREWS TYPE KS
RAMPA countersunk screws type KS (comply tiwh DIN 7991) with hex drive and decorative countersunk head for visible joints.
Cutsomers also bought
RAMPA KNOCK-IN INSERTS TYPE TSZ
RAMPA knock-in inserts type TSZ with continous internal thread and four strong pikes on the shank for strong hold without torsion.
RAMPA FLAT HEAD SCREWS TYPE KFS
RAMPA flat head screws type KFS with hex drive, guide shaft and decorative head for visible joints.
RAMPA CAP NUTS TYPE RFL
RAMPA cap nuts type RFL with hex drive, blind hole and decorative flat head for visible joints.
RAMPA FLAT HEAD SCREWS TYPE KF
RAMPA flat head screws type KF with hex drive and decorative head for visible joints.
RAMPA INSERTS TYPE SKD330
RAMPA inserts type SKD330 with sealing collar, hex drive, unthreaded lead and patented 3-start thread contour for tilt protection and quicker assembly. Highest possible pull-out values in various wood, wood-based materials and thermoplastics.
Similar products
RAMPA KNOCK-IN INSERTS TYPE TS
RAMPA knock-in inserts type TS with collar, continuous internal thread and knurled shank. Enables reliable positioning in the assembly process.
RAMPA KNOCK-IN INSERTS TYPE TSZ
RAMPA knock-in inserts type TSZ with continous internal thread and four strong pikes on the shank for strong hold without torsion.
RAMPA KNOCK-IN INSERTS TYPE TSBZ
RAMPA knock-in inserts type TSBZ produced by zinc die casting process with collar and strong spikes on the shank for strong hold without torsion. Note: Zinc die-cast parts have decreasing retention forces and a shortened product life cycle.
RAMPA KNOCK-IN INSERTS TYPE TSLZ
RAMPA knock-in inserts type TSLZ produced by zinc die casting process with collar and spikes on the shank for strong hold without torsion. Note: Zinc die-cast parts have decreasing holding forces and a shortened product life cycle.
RAMPA KNOCK-IN INSERTS TYPE TS3L
RAMPA knock-in inserts type TS3L with three fixing holes (Ø 3 mm) for additional securing with e.g. screws or nails.